標題：基于正交試驗法的沖壓件滑移線數值模擬研究
作者：瞿二虎1，李明哲2，許海媚3，潘瑞民4，李虎5 ，文英6，王成志1，李丹彤7（1.北京亞太汽車底盤系統有限公司技術部，北京100000；2.吉林大學材料科學與工程學院，吉林長春130025；3.河北工業大學材料科學與工程學院，天津300000；4.天津市職業技術師范大學經濟與管理學院，天津300000；5.宜賓同濟汽車研究院有限公司整車開發部，四川宜賓644000；6.浙江眾泰汽車制造有限公司杭州分公司NVH工程開發部，浙江杭州310000；7.北京汽車研究總院越野車研究院，北京100000）
摘要：以某汽車行李箱外板上板為研究對象，基于正交試驗，對不同參數下成形的沖壓件產生的滑移線進行了數值模擬分析，結果表明：采用正交試驗法可快速獲得最優成形工藝參數組合，并得出各工藝參數對沖壓件滑移線的影響程度，降低了試驗次數和成本，提升了工作效率。
關鍵詞：滑移線；沖壓成形；數值模擬；正交試驗；工藝參數
中圖分類號：TG76；O242.21 文獻標識碼：B 文章編號：1001-2168（2020）07-0010-05
DOI：10.16787/j.cnki.1001-2168.dmi.2020.07.003
Numerical simulation research on slide line of stamping parts based on orthogonal test
QU Er-hu1, LI Ming-zhe2, XU Hai-mei3, PAN Rui-ming4, LI Hu5, WEN Ying6, WANG Cheng-zhi1, LI Dan-tong7 (1.Technical Department, Beijing Yatai Automobile Chassis System Co., Ltd., Beijing 100000, China; 2.College of Materials Science and Engineering, Jilin University, Changchun, Jilin 130025, China; 3.School of Materials Science and Engineering, Hebei University of Technology, Tianjin 300000, China; 4.College of Economics and Management, Tianjin University of Technology and Education, Tianjin 300000, China; 5.Vehicle Development Department, Yibin Tongji Automobile Research Institute Co., Ltd., Yibin, Sichuan 644000, China; 6.NVH Engineering Development Department, Zhejiang Zotye Automobile Manufacturing Co., Ltd., Hangzhou branch, Hangzhou, Zhejiang 310000, China; 7.SUV research institute, Beijing Automotive Research Institute Co., Ltd., Beijing 100000, China）
Abstract: Taking the outer panel of a car trunk as the research object, based on the orthogonal test, the numerical simulation analysis of the slip line on products formed under different parameters was carried out. The results showed that the orthogonal test could be used to quickly obtain the optimal combination of process parameters, and the influence degree of each process parameter on the slip line of stamping parts was obtained.
Key words: slip line; stamping forming; numerical simulation; orthogonal test; process parameters